Fiat Idea - Page 149

148
STARTING
AND DRIVING
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
ALPHABETICAL
INDEX
DASHBOARD
AND
CONTROLS
SAFETY
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
fig. 20
F0H0181m
fig. 21
C
B
D
F0H0214m
fig. 22
F0H0182m
DIPPED BEAM HEADLIGHTS
To change the bulb, proceed as follows:
❒ remove protective cap by releasing the
corresponding retainer;
❒ disconnect the electric connector F-
fig. 22;
❒ release the bulb holder clip E;
❒ remove the bulb G and replace it;
fig. 23
F0H0183m
DIRECTION INDICATORS
Front
To change the bulb, proceed as follows:
❒ remove protective cap by releasing the
corresponding retainer;
❒ turn the bulb holder anticlockwise A-
fig. 23 and pull it out;
❒ remove the bulb by pushing it sligh-
tly and turning it anticlockwise;
❒ replace the bulb;
❒ refit the bulb holder by turning it
clockwise and locking it properly.
❒ refit the protective lid correctly.
❒ fit the new bulb, ensuring that the ou-
tline of the metal part coincides with
the grooves on the curve of the head-
light. Then reconnect the electrical
connector E and reattach the bulb
holding clip F;
❒ refit the protective lid correctly.