Fiat Idea - Page 150

149
STARTING
AND DRIVING
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
ALPHABETICAL
INDEX
DASHBOARD
AND
CONTROLS
SAFETY
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
Side
To change the bulb, proceed as follows:
❒ lever in the point shown by the arrow
in order to compress the fastening
spring and extract the unit C-fig. 24;
❒ turn the bulb holder D anticlockwise,
extract the clipped bulb and replace it;
❒ refit the bulb holder D in the lens,
then position the assembly to the unit
making sure that the fastening clip
clicks.
fig. 24
F0H0184m
FRONT SIDE LIGHTS
To change the bulbs, proceed as follows:
❒ remove protective cap by releasing the
corresponding retainer;
❒ remove snap-fitted bulb holder A-
fig. 25, remove the bulb Band re-
place it;
❒ refit the snap-fitted bulb holder A;
❒ refit the protective lid correctly.
FRONT FOG LIGHTS
(where provided)
To change the bulb, proceed as follows:
❒ disconnect the electric connector C-
fig. 26;
❒ release the bulb holder clip D;
❒ remove the bulb E and replace it;
❒ refit the new bulb, fasten the bulb hol-
der clip D and reconnect the electric
connector C.
fig. 25
F0H0185m
fig. 26
F0H0186m