172
STARTING
AND DRIVING
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
ALPHABETICAL
INDEX
DASHBOARD
AND
CONTROLS
SAFETY
WARNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
BRAKE FLUID fig. 14
Release cap: Check that the liquid contai-
ned in the tank is at the maximum level.
Fluid level in the reservoir must not ex-
ceed the MAX mark.
Use the brake fluid shown in the “Fluids
and lubricants” table (see “Technical Spe-
cifications”).
NOTE Carefully clean the cap of reservoir
A and the surrounding surface.
When opening the cap, make sure that no
dirt gets into the reservoir.
Always use a funnel with a built-in filter
with a mesh of 0.12 mm or less for top-
ping up.
IMPORTANT Brake fluid absorbs moi-
sture. For this reason, if the car is mainly
used in areas with a high degree of atmo-
spheric humidity, the fluid should be re-
placed at more frequent intervals than
specified in the “Service schedule”.
fig. 14
F0H0213m
Brake fluid is poisonous and
highly corrosive. In the event
of accidental contact, wash the parts
immediately with water and mild
soap and rinse with plenty of water.
Call a doctor immediately if swal-
lowed.
WARNING
Symbol
π
on the contain
indicates a synthetic brake
fluid, which is different from a mine-
ral fluid. Use of a mineral type fluid
will damage the special rubber seals
of the braking system beyond repair.
WARNING
Prevent brake fluid which is
highly corrosive from coming
into contact with painted
parts. Should this occur, im-
mediately wash with water.
Do not travel with the wind-
screen washing reservoir
empty: the action of the windscreen
washer is essential for improving vi-
sibility.
WARNING
Some commercial additives
for windscreen washing are
flammable. The engine compartment
contains hot parts which could start
a fire if they come into contact.
WARNING
fig. 13
F0H0212m
To Next Page
Loading...
