IN AN EMERGENCY
160
GENERAL INSTRUCTIONS
– When a light is not working, check
that it has not fused before changing
the bulb.
– For the location of the fuses, refer
to “If a fuse blows” in this chapter.
– Before replacing a bulb that does
not work, check that the contacts are
not oxidised.
– Burnt-out bulbs must be replaced
with ones of the same type and pow-
er.
– Always check the height of the
headlight beam after changing a bulb.
TYPES OF BULBS fig. 12
Several types of bulbs are installed in
the vehicle:
A - Glass bulbs: clipped into position.
Pull to remove.
B - Bayonet bulbs: remove from the
bulb holder by pressing the bulb and
turning it anticlockwise.
C-D - Halogen bulbs: to remove the
bulb, release the clip holding the bulb
in place.
E - Xenon bulbs.
fig. 12
F0B0127b
To Next Page
Loading...
