GETTING TO KNOW YOUR CAR
25
ELECTRICALLY
ADJUSTABLE HEATED
FRONT SEATS fig. 26-27
(for versions/markets, where provided)
Adjustments can be made when the
key is at M, and for about 1 minute af-
ter turning the key to S.
A - button for moving the seat back-
wards and forwards;
B - button for adjusting the angle of
the seat back;
C - seat heating on/off switch with
the engine running. The seat heating
can be adjusted according to 4 differ-
ent levels: 0 (off), 1 (minimum heat-
ing), 2 (medium heating), 3 (maximum
heating);
D - Controls for the driver’s seat po-
sition storing.
STORING PROCEDURE FOR
DRIVER’S SEAT fig. 27
(for versions/markets, where provided)
The system makes it possible to
store 2 different driver's seat positions
connected to buttons 1 and 2.
Proceed as follows to store the ad-
justments available with button 1 and
2 and the ignition key at M:
– put the seat in the required posi-
tion;
– press button M and then, within 4
seconds, press button 1 to store the
adjustment in “memory 1” or button
2 to store the adjustment in “memo-
ry 2”.
A sound signal accompanies suc-
cessful storing.
Recalling a stored position
When the engine is off: briefly press
button 1 or 2.
IMPORTANT After 5 unsuccess-
ful recalls, the system locks the rela-
tive control which will be restored
when the engine is started.
When the engine is on: press and
keep button 1 or 2 pressed until the
stored position is reached.
fig. 26
F0B0020b
fig. 27
F0B0285b
To Next Page
Loading...
