12
ADVANCED PARAMETERS
#9: Advanced parameters
The Wall Plug allows to customize its operation to user’s needs. The
settings are available in the FIBARO interface as simple options that
may be chosen by selecting the appropriate box.
In order to congure the Wall Plug (using the FIBARO Home Center
controller):
1. Go to the device options by clicking the icon:
2. Select the „Advanced” tab.
3. Modify values of chosen parameters.
4. Save the changes.
GENERAL SETTINGS
1. “Always On” mode
In this mode Wall Plug will turn on connected device permanently and
will stop reacting to attempts of turning it o (through Z-Wave network
or pushing the B-button).
“Always On” function turns the Wall Plug into a power and energy me-
ter. Connected device will not be turned o upon receiving an alarm
frame from another Z-Wave device (parameter 31 will be ignored).
In “Always on” mode, connected device may be turned o after ex-
ceeding the power dened in parameter 3 or in case of detecting
current greater than 110% of rated current. In such cases, connected
device can be turned on again by pushing the B-button or sending a
control frame. By default, overload protection is inactive.
Available settings: 0 - function inactive
1 - function activated
Default setting: 0 Parameter size: 1 [byte]
2. Remember device status before the power failure
This parameter determines how the Wall Plug will react in the event
of power supply failure (e.g. power outage or taking out from the
electrical outlet).
After the power supply is back on, the Wall Plug can be restored to
previous state or remain switched o.
This parameter is ignored in „Always On” mode - the device automat-
ically turns ON after plugging it into the socket.
Available settings: 0 - device remains switched o
1 - device restores the state from before the
power failure
Default setting: 1 Parameter size: 1 [byte]
To Next Page
