FIBARO FGWP-102 - Technical Specifications of FIBARO Wall Plug

19
SPECIFICATIONS
Power supply:
Rated load current
(for resistive load):
Power consumption:
Power output (for resistive
load):
To be used with E or
F type (Schuko) sockets:
Active element:
EU standards compliance:
Pollution Degree:
Radio protocol:
Radio frequency:
Range:
Operating temperature:
Dimensions (Diameter x
Height):
230V AC, 50/60 Hz
11A - continuous load
up to 1.6W
2.5kW at continuous load
- CEE 7/16 - max load 2.5A
- CEE 7/17 - max load 11A
- Dual type plugs E/F
Micro-gap relay switch 
RoHS 2011/65/EU
RED 2014/53/EU
2 (home and oce use, indoor only)
Z-Wave (500 series chip)
868.4 or 869.8 MHz EU;
908.4, 908.42 or 916.0 MHz US;
921.4 or 919.8 MHz ANZ;
869.0 MHz RU;
up to 50m outdoors
up to 40m indoors
(depending on terrain and building
structure)
0 - 40°C
43 x 65 mm
Safety classication rating: home and oce use only
Type 1 action according to features of automatic action as per clause
6.4.1 of EN 60730-1:2012 standard.
Software class A device, according to EN 60730-1:2012 standard.
#10: Specications
NOTE
In case of loads other
than resistive please
observe cosφ and, if
necessary, use load
lower than rated. It is
recommended not to
exceed 3A for 250 V
AC, cosφ=0.4.
i
NOTE
Radio frequency of
individual device
must be same as your
Z-Wave controller.
Check information
on the box or consult
your dealer if you are
not sure.
i