Operation Safety Rules
High optical power can cause bodily harm, especially to eyes.
Never look directly into the end of the optical transmitter fiber
jumper or the end of its active connector.
Exercise care if you must bend fibers. If bends are necessary,
the fiber bending radius should never be less than 38mm.
Power socket overload, broken cables or broken plugs may
cause electric shock or fire. Regular check-ups on power
supply wires and cables are essential. If any appear damaged,
replace at once.
Use the power supply adapter provided in the package
only. Using other adapters may cause equipment damage
or operation failures.
Install the equipment in a well ventilated environment
without high temperatures or direct sunlight to protect the
equipment and its components from overheating, which can
result in damage.
Avoid moisture, dampness and water damage. Equipment
exposed to water cannot work normally and can be
extremely hazardous due to shorting.
Do not lay this equipment on an unsteady base.
I
To Next Page
Loading...
Need help?
General
