(lb) weight
units (F9)
This instrument supports conversion among kg, g and lb. To enable this
conversion function, set F9 = ON. Press [Unit] to shift among various weight
units.
The weight unit employed before power off will be employed when powered
on again.
6.4 Tare off the Weight of a Container
Tare function is used to temporarily set the scale to zero (such as cancelling
the weight of a box or a container) in order to get the net weight result
6.4.1 Manual Tare
When a container is used, follow the below steps to tare off the weight of it
and to get a net weight result.
a. Remove all loads from platform,
b. Make sure that the Zero Indicator is on. If not, press [Zero],
c. Place container on platform,
d. Press [Tare] ,
e. Net Indicator appears to indicator tare is in effect and weight displayed
display is net weight.
f. To cancel tare effect, remove all loads from platform and press [Tare],
g. Net Indicator disappears. Gross Indicator appears to indicator tare
effect has been removed and weight displayed display is gross weight.
6.4.2 Auto Tare
(F12)
If this function is enabled, this instrument will assume the first stable weight
applied is a container and will tare off the weight of it automatically.
When container is removed and gross weight result = zero, tare effect will be
cancelled automatically.
To comply with the laws of certain countries and approval requirements, the imperial
weight unit may be disabled. Contact your dealer for more information.
To Next Page
Loading...