Maximum 15 lines can be entered.
16 variants + 2 commands (Cr LF and End) are available for custom print
output format. Refer to the Below Print Output Format Variants Table for
more detail.
8.2.1 To Edit Custom Print Output Format
Follow the below steps to create custom printout.
a. Go to internal function and select the desired function number to edit,
b. Select CUSTOM and press [M+],
c. This instrument displays Line 1 and the last variant or command (see
8.2.2 for details) stored,
d. Press [M+] to confirm or select other variant or command by press
[FUNC] or [UNIT]. Then press [M+] to confirm and save,
e. This instrument displays Line 2 and the last variant or command
stored,
f. Repeat steps d and e for other lines,
g. (In case, number of lines to be printed is less than 15 lines) To finish
editing, select command End, then pres [M+] to confirm.
h. This instrument returns to and displays the current internal function
number,
i. If required, repeat steps a to h to create and edit custom printout
format for other functions.
To Next Page
Loading...