76
Description
Your SC680 is the top of the line clamp meter with
wireless functionality for the HVACR professional. Send
your electrical measurements directly to the Job Link®
System mobile app. Leave the meter behind a closed
blower door and view the current measurement on your
mobile device.
Help determine system efficiency by directly
measuring power consumption (W) of the system. Use
this value to inform your customer of energy saving
measures you can take to help them save money on
their energy bills.
The SC680 is the only meter you’ll need for
troubleshooting mini-split systems. Dual Type K
temperature ports to measure entering/exiting air
temperatures and measure frequency (Hz) directly with
clamp jaw. Reach those cramped mini-split connectors
with the included RCT2 probe tips for voltage and
resistance measurements.
Hang your SC680 clamp meter to any metallic surface
with the heavy-duty magnet. When the job is done, store
your test leads in the back case for tidy and convenient
storage. See both voltage and amperage readings at the
same time on the large dual display.
Easily see your amperage readings no matter how you
clamp around a wire with the swivel head AAC clamp.
Verify the order of 3-phase voltage lines with just two
leads. Capture L1-L2 and L1-L3 to check that motor lines
are correctly installed with Phase Rotation test.
Take more accurate VAC and AAC readings on variable
frequency drives with True RMS sensing technology.
Measure the starting amp draw of a compressor with
Inrush current mode.
Illuminate the way with a powerful LED built into the
clamp jaw. Easily see your measurements with the bright
blue backlight on the display. Safely change functions
with the backlit illuminated dial.
Take measurements more safely with one hand
using the single test lead holder. Test leads come with
removable gold plated tips to reliably connect Fieldpiece
accessory heads.
What’s Included
• SC680 Job Link® System Power Clamp Meter
• ADLS2 Deluxe Test Leads Kit
• ASA2 Alligator Clips
• RCT2 Molex Probe Tips
• 2 ATB1 Type K Thermocouples
• 2 Velcro Straps
• 9V Alkaline Battery (Not installed)
• ANC7 Protective Padded Case
• Operator’s manual
Quick Start
1. For electrical testing, connect test leads to black "COM"
and red "+" jacks.
2. Rotate the dial to your desired measurement.
3. Connect to test points and read measurement.
4. For temperature testing, remove test leads, slide TEMP
switch to the right and connect Type K thermocouples.
To Next Page
Loading...
Need help?
General
