Need help?Do you have a question about the Fieldpiece SMAN SM380VINT and is the answer not in the manual?
General| Brand | Fieldpiece |
|---|---|
| Model | SMAN SM380VINT |
| Category | Measuring Instruments |
| Language | English |
Safety information for handling specific refrigerant classes.
Lists essential safety warnings and precautions for operating the manifold.
Provides step-by-step instructions for initial setup and use.
Lists the components provided with the SMAN Refrigerant Manifold.
Introduces the SMAN manifold and its capabilities.
Outlines the primary capabilities and attributes of the SMAN manifold.
Explains the various readouts and symbols shown on the manifold's screen.
Identifies the physical buttons on the manifold's control panel.
Identifies ports, sight glass, and associated valves.
Describes pipe clamp storage and the Micro USB port.
Identifies the LOW/HIGH port valves.
Locates battery access points and the hanging hook.
Identifies the Liquid Line, Outdoor, and Suction Line thermocouple jacks.
Explains the ID used for wireless connectivity and reporting.
Provides detailed explanations of each button's purpose and operation.
Describes the feature that stores the 10 most recently used refrigerants.
Explains how to cycle through readings and select psychrometer data.
Explains how to measure and view superheat and subcooling.
Details how to calculate TSH using indoor and outdoor temperatures.
Provides step-by-step instructions for performing a deep vacuum test.
Offers advice to improve the efficiency and accuracy of evacuation procedures.
Guides users through performing a pressure test with dry nitrogen.
Explains how to identify and measure noncondensables in a system.
Lists all available menu options and their corresponding page numbers.
Explains how to set up and start logging measurements and calculations.
Details how to configure the automatic power-off timer to save battery.
Provides steps for calibrating thermocouples using an ice water bath.
Guides assigning wireless Job Link tools to manifold measurements.
Explains how to assign sources for TSH calculations (IDWB/ODDB).
Describes setting measurement units and configuring vacuum alarms.
Details how to configure the display backlight auto-off duration.
Describes calibrating pressure sensors using refrigerant P-T data.
Lists common causes for an "Err" message during calibration.
Explains how to view firmware versions and perform updates.
Guides on resetting the manifold to factory default user settings.
Describes deleting logs and formatting the internal flash drive.
Provides instructions for cleaning and replacing batteries.
Advises on purging the manifold when switching refrigerants.
Refers to pages for Temperature and Advanced Pressure Calibration.
Lists display, power, range, and environmental specs.
Details wireless range, data port, and supported refrigerants.
Details the temperature sensor type, range, resolution, and accuracy.
Details pressure sensor type, port type, ranges, resolution, and accuracy.
Details the vacuum sensor type, range, resolution, and accuracy.
Lists device requirements and tool assignments for wireless connectivity.
Illustrates the arrangement of sensors, ports, and valves.
Shows CE, UK CA, FCC, IC, and RoHS compliance symbols.
Details FCC cautions, interference rules, and radiation exposure limits.
Details IC cautions, interference rules, and radiation exposure limits.
Outlines the one-year warranty against defects and exclusions.
Provides website and distributor information for obtaining service.
To Next Page