Fiery KM-C3130 - Configuring a Connection for Fiery Downloader

2
2-16 Installing User Software on a Mac OS Computer
Modifying the configuration
Edit the configuration whenever there is any change to your Fiery X3e or network,
such as an IP address or device change. Change the specific Fiery X3e Setup
information before configuring the connection.
TO MODIFY THE CONFIGURATION
1. In the Chooser dialog box, click Option.
2. To edit information for a Fiery X3e, select the Fiery X3e by its IP address or DNS name
and click Modify. Edit information in the Settings dialog box as necessary, and click
OK.
3. To add a new Fiery X3e, click Add. Configure the Settings dialog box as outlined in
steps 4 through 6 in the preceding procedure.
4. To remove a Fiery X3e, select the Fiery X3e by its IP address or DNS name, and click
Remove.
The list of available servers reflects the modifications you have made.
Configuring a connection for Fiery Downloader
When you start Fiery Downloader, you must specify the connection to the Fiery X3e.
BEFORE YOU BEGIN
• Print the Configuration page from the Control Panel and note the AppleTalk zone of
the Fiery X3e.