14
AT THE END OF THE WORK
1. AT THE END OF THE WORK
t the end of the work, and before carrying out any type of maintenance:
1. Bring the machine to the place provided for debris discharge
2. Position the machine's main switch (d) to “0” (for FS50 B-BT versions)
3. Turn the engine's main switch to "OFF" (for versions FS50 H-HT), see user manual for the Honda
GX100 engine supplied with the machine
4. Activate the lever several times to shake the filter, for versions with electric shaker do this before
shutting down the machine
5. Remove the debris hopper from its housing and empty it
ATTENTION: These operations must be carried out using gloves to protect the
hands.
2. STORING OF THE MACHINE
Proceed as follows to store the machine at the end of work:
1. Park the machine in a covered area protected from the weather, and on a flat and level surface;
objects that can damage or be damaged through contact with the machine must not be present
close to the machine.
2. Position the machine's main switch to “0” (for FS50 B-BT versions) and disconnect the machine
connector
3. Turn the engine's main switch to "OFF" (for versions FS50 H-HT), see user manual for the Honda
GX100 engine supplied with the machine
4. Lift the side brush
To Next Page
Loading...
