Need help?Do you have a question about the Fimap GENIE E and is the answer not in the manual?
General| Model | GENIE E |
|---|---|
| Category | Floor Machine |
| Working width | 35 cm |
| Battery Voltage | 24 V |
| Type | Scrubber |
| Solution tank capacity | 15 L |
| Recovery tank capacity | 15 L |
Details about the machine's packaging, dimensions, and weight.
Instructions for safely removing the machine from its packaging.
Guidance on moving and transporting the machine after unpacking.
Steps for connecting the machine's extension lead to a power socket.
Essential pre-operation checks, connections, and switch settings before starting work.
Explanation of the overflow device function and the procedure when the recovery tank is full.
Steps to safely turn off the machine, including switches and power cable disconnection.
Procedures for draining water, disconnecting pipes, and removing the recovery tank.
Instructions for disassembling and cleaning the brush after completing work.
Steps to unplug the machine, disconnect hoses, and clean the recovery tank.
Procedure to safely empty the solution tank by switching off the machine and disconnecting components.
Procedure for cleaning the squeegee tube to ensure proper suction and prevent blockages.
Steps for cleaning the solution tank and its filter for consistent water emission.
Information on the thermal trip unit and advice for repeated machine stops.
Checks for filter, switches, connections, and vent pin when water supply is low.
Troubleshooting steps for when the machine does not clean effectively, including brush wear.
Checks for squeegee cleanliness, tube insertion, distributor, and rubber wear.
Causes of excessive foam and solutions like using low-foam detergents or diluting the solution.
To Next Page
