Fimap GENIE E - Choosing and Using Brushes; Suggested Power Cable Extension

19
CHOOSING AND USING THE BRUSHES
POLYPROPYLENE BRUSH (PPL)
Used on all types of floors. Good resistance to wear and tear, and hot water (no greater than 60°C.). PPL is non-hygroscopic and therefore retains its
characteristics even when working in wet conditions.
PAD HOLDER
The pad holder is recommended for cleaning shiny surfaces.
There are two types of pad holders of the CENTRE LOCK type, equipped with a snap-type central locking system in plastic that allows the abrasive floor
pads to be perfectly centred and held without any risk of them becoming detached:
1. fitted with a series of anchor points that allow the abrasive floor pad to be held and dragged while working
2. fitted with a series of groups of bristles that allow the abrasive floor pad to be held and dragged while working
TABLE FOR CHOOSING THE BRUSHES
Machine
No. of brushes
Code Type of bristles
Bristles  Brush
Notes
GENIE E 1
421701
422213
422001
PPL
Pad holder – anchor
Pad holder – bristles
0.6
0.9
355
355
355
SUGGESTED POWER CABLE EXTENSION
CAST SCHUKO PLUG
CAST SCHUKO PLUG