14
DAILY MAINTENANCE
PERFORM ALL MAINTENANCE OPERATIONS IN SEQUENCE
1. CLEANING THE RECOVERY TANK
1. Make sure the power cable of the machine is unplugged from the outlet
2. Disconnect the suction hose from the recovery tank
3. Disconnect the hook securing the recovery tank on the rear of the machine.
4. Remove the recovery tank.
ATTENTION: This operation must be carried out wearing gloves to
protect against contact with dangerous solutions.
ATTENTION: Before carrying out any type of maintenance, disconnect
the machine's power supply cable.
5. Remove the caps to open the tank.
6. Clean the filter under running water.
7. Rinse the tank and clean with a jet of water
ATTENTION: This operation must be carried out wearing gloves to
protect against contact with dangerous solutions.
2. EMPTYING THE SOLUTION TANK
Proceed as follows to empty the solution tank:
1. Switch off the solenoid valve switch
2. Switch off the suction switch
3. Switch off the main switch
4. Disconnect the power cable from the socket
5. Disconnect the quick connector on the front of the solution tank
6. Insert the Genie E solution tank discharge pipe kit (optional)
ATTENTION: This operation must be carried out wearing gloves to
protect against contact with dangerous solutions.
To Next Page
Loading...
