17
WEEKLY MAINTENANCE
1. SIDE BRUSH ADJUSTMENT
The brush height adjustment is made by means of screw (a) inside the support bracket (b) of the brush.
The brush must be compressed against the ground for about 2 cm.
2. CENTRAL BRUSH ADJUSTMENT
The central brush should operate flattened to the ground by 7/8 mm. The height adjustment is made by
means of the adjustment nuts on the sides of the machine. Respect the alignment of the brush during
adjustment.
3. ENGINE MAINTENANCE (FS50 H-HT VERSION)
WARNING: As for maintenance work on the motor, we suggest to closely follow
the MOTOR USER MANUAL supplied with the machine.
To Next Page
Loading...
