Fimar H/220 - Troubleshooting

- 12 - English language
H-HS-HL GRAVITY
SLICERS
GB
Important
Only clean with food safe detergents. Never use corrosive or flammable cleaning
products or products that contain substances harmful to human health.
For long periods of disuse, after cleaning and turning off appliance power (or unplug-
ging the power cord), adequately cover it to keep it clean.
TROUBLESHOOTING
The purpose of the following information is to help the operator to identify and correct
any anomalies or malfunctions that may occur during use.
If one of the faults listed in the table occurs, inform the manufacture to actively contrib-
ute in developing new solutions and improving construction techniques.
Some faults may be resolved by the user, others require specific technical skills or abil-
ities and must only be performed by qualified personnel with recognised experience in
the specific sector.
Important
Do not remove internal appliance parts.
The manufacturer is not liable for any machine tampering!
Table 2: Operating malfunctions
Problem Causes Solutions
The equipment does not start.
No mains power.
Make sure the electrical mains
are correctly connected.
Contact your dealer or
authorised service centre.
Blade cover incorrectly
assembled.
Check correct assembly.
The appliance does not start
and emits a continuous noise
like a hum (only for three-phase
powered appliances)
The electric motor is operating
with single-phase current.
Electrical mains circuit fault.
Stop the appliance and have an
expert technician check the
electrical mains circuit.
Blade rotation direction is
incorrect (only for three-phase
powered appliances).
Appliance power phase wires
are incorrectly connected.
Have an expert technician
invert power wires.
The appliance starts but the
indicator light does not turn on.
Indicator light broken.
Contact your dealer or
authorised service centre.
The appliance vibrates, the
electric motor overheats and a
bad odour is emitted when
running.
Electric motor or transmission
unit fault.
Use the specific turnbuckle
(under the base, next to the
motor) to tension the belt. If the
problem persists, contact your
dealer or authorised service
centre.