USE AND MAINTENANCE MANUAL
USE AND MAINTENANCE MANUAL
Fimer S.p.a. thanks you for selecting this unit, it will prove to be a useful, problem-free
tool for many years to come if the instructions contained in this manual are followed scru-
pulously.
This manual must be considered as an integral part of the unit and must accompany it
when it change location or is resold.
The user must assume responsability for maintaining this manual intact and legible at all
times.
Fimer S.p.a. reserves the right to modify this manual at any time without notice.
All rights of translation and total or partial reproduction by any means whatsoever (inclu-
ding scanner, photocopy, film, and microfilm) are reserved and reproduction is prohibited
without the express written consent of Fimer S.p.a.
INDEX
INDEX
• WARNING .........................................................................................................
............................................................................................................... pag. 2, 3, 4
1. GENERAL INFORMATION...................................................................... pag. 5
2.
DESCRIPTION OF WELDER ............................................................... pag. 6
3. WELDING METHODS ............................................................................... pag. 8
3.1 MIG/MAG WELDING ............................................................................. pag. 8
3.1.1 MANUAL MIG WELDING .................................................................... pag. 8
3.1.2 SYNERGIC SHORT ARC MIG WELDING ............................................... pag. 9
3.2 MMA WELDING ................................................................................... pag. 9
4. CONNECTION TO POWER SUPPLY ....................................................... pag. 9
5. OUTPUT CONNECTIONS ...................................................................... pag. 10
5.1 MIG WELDING CONNECTIONS WITH SHIELDING GAS ....................... pag. 10
5.2 MIG WELDING CONNECTIONS - GASLESS ......................................... pag. 10
5.3 MMA WELDING CONNECTIONS .......................................................... pag. 10
6. WELDING WIRE INSTALLATION ............................................................. pag. 10
7. GAS CYLINDER AND GAS PRESSURE REGULATOR CONNECTIONS..... pag. 11
8. WELDING METHODS ........................................................................... pag. 12
8.1 MANUAL MIG WELDING .................................................................... pag. 12
8.2 SYNERGIC MIG WELDING.................................................................. pag. 12
8.3 MMA WELDING .................................................................................. pag. 13
8.3.2 MMA WELDING FEATURES.................................................................... pag. 13
8.3.3 MMA WELDING ....................................................................................... pag. 14
9. WIRE LINER REPLACEMENT ............................................................... pag. 15
10.TROUBLE SHOOTING .......................................................................... pag. 16
11. BLOCK DIAGRAM ............................................................................... pag. 16
To Next Page
Loading...
