EasyManua.ls Logo

FingerTec TA100C - TIPS FOR BEST FINGERPRINT ENROLLMENT

FingerTec TA100C
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
CONTENTS
UPRIGHT ASKEW
OFF CENTER PART
1
USE INDEX FINGER
Index finger is smaller than thumb and it can be comfortably placed on the sen-
sor. The use of thumb is not recommended because the center points might not
be placed properly on the sensor, hence cannot be read by the sensor.
2
makE SURE THE FINGER IS NOT WET, TOO DRy, INjURED OR DIRTy
The finger needs to be slightly moist to enable the sensor to read the minutiae
points on the fingerprint.
3
pLaCE THE CENTER pOINTS OF yOUR FINGER aT THE CENTER OF THE
SENSOR
The center points of a finger is an area where there is a swirl and the center
points must be properly placed on the sensor during enrollment.
4
DON’T pRESS HaRD aT THE SENSOR, jUST pLaCE yOUR FINGER ON
THE SENSOR
The sensor is reading minutiae points of your finger and placing a finger properly
on the sensor will prompt the sensor to read those points. Pressing your finger
hard on the sensor is not necessary.
5
DON’T DO ENROLLmENT UNDER BRIGHT LIGHT OR DIRECT SUNLIGHT
It is important to note that bright light or sunlight could interfere with reading of
the sensor. Avoid placing the terminal under direct sunlight or bright light to avoid
difficulty in enrollment and future verification.
TIpS FOR BEST
FINGERpRINT ENROLLmENT
WHaT yOU SHOULD DO
Place finger flat on the fingerprint sensor. Make sure
the finger’s midpoint is placed at the center of the
fingerprint sensor.
WHaT yOU SHOULD NOT DO

Other manuals for FingerTec TA100C

Related product manuals