4 Using this Manual
In the tables below we have described when you should use an option, provided
a quick how to, and detailed step-by-step instructions.
Remember [#] clears any unintended entries and [*] is the enter/save key.
5 Arming your system
Depending on the way your alarm has been installed- there are several ways to
arm the system.
5.1 Away Arm
When You are leaving the premises, and there is no one else on
site/at home.
How
Touch [#] and then [USER CODE]
Leave via your exit zone.
Step-by-step
Ensure the partition/s you want to arm are ready to
arm (illuminated green). If not check that all
monitored windows and doors are closed.
Touch the [#] key to clear any key entries.
Enter a valid [USER CODE]. If you make any
mistakes, touch [#] and re-enter the code.
The Keypad will beep and the P key will flash
orange for the duration of the entry/exit delay.
Should leave via the entry/exit route.
The panel will arm at the end of the entry/exit delay,
and the keypad sound a long beep.
Note Depending on the type of user, they can only arm and
disarm partitions that they are assigned to.
If you do not violate the entry/exit zone during the
entry/exit delay- the panel will arm in Home1.
5.2 Quick Arm Away
To Next Page
Loading...