any unintended entries.
Enter the valid [DURESS CODE].
If a correct code is entered, the system will disarm
normally, however a duress alarm will be reported to
your monitoring company. This will tell them you
have been forced to disarm and require emergency
response.
If you have entered an incorrect code, the keypad
will beep. Touch [#] and re-enter the correct code.
Note Only use in an emergency situation.
The Duress Code will be set by your installer and should
be something that is easy to remember for your whole
family/staff.
10 User Codes
Up to 64 users are supported by the mi64, and user codes must be 4 digits long.
If you are a Master User, you can assign, edit or delete users.
Each user may be assigned to one, or any combination of partitions. By default
they will be assigned to all partitions.
10.1 Programming User Codes
When programming user codes your will need to select an function value:
Table 1: Programming User Codes- Function Values
Value Function Partition Status Indicators
1 Add a new user Green, Orange, Orange, Green
2 Edit an existing user Orange, Orange, Green, Green
3 Delete a user code Green, Red, Red, Green
4 Delete a user by
number
Red, Green, Green, Red
When This should be used by a Master User to add, edit or delete
users.
How
Touch the [ALT] key followed by the [*] key.
Enter a [MASTER USER CODE] followed by the
[*] key.
Select your [OPTION VALUE] from the table
above.
Touch [*].
To Next Page
Loading...