How to lay River Rocks
• Lay large rocks first, in these positions.
• Lay small rocks next, in these positions.
• With glass still removed, switch the appliance on
at ‘HIGH’ setting to check how flame looks. The
flame will take 10-20 seconds to light fully.
• IMPORTANT: the flame effect should look natural and non-uniform, running the entire length of the burner.
• Common flame effect issues are:
o Flame touching edge of burner tray.
o Missing flames along length of burner.
• Both these issues can be resolved by switching the appliance off and slightly repositioning rocks and logs at
the problem areas.
• Repeat this switching on/off and repositioning until a natural and non-uniform flame effect is achieved.
• Once a natural and non-uniform flame effect is achieved, switch the appliance to ‘LOW’ setting and ensure
the flame effect, although smaller, still looks good.
• Switch the appliance off and carefully fit the glass. Follow the ‘Glass Installation Process’ in this guide.
• Switch the appliance on and check that flame effect still looks natural and non-uniform.
• Fit the front cover. Follow the ‘Front Cover Installation Process’ in this guide.
• Note: it is normal for the glass to mist a little when the appliance is first switched on. This will quickly
disappear.
To Next Page
Loading...