FireClass ESSENTIAL 2 - Page 17

Functionality in access level 1 and 2
Figure 4: Access level 1 and 2 functions
Press the Function
button for more than 5
seconds.
Press the
Silence/Resound/Evacuation
button.
Sounders can be silenced.
Sounders can be resounded.
Manual evacuation
Navigates between
zones and sounders
in the case of
enable/disable
programming,
between zones
in test
programmig,
and delay to output
programming.
Navigates between
zones and sounders
in the case of
enable/disable
programming,
between zones
in test
programming,
and delay to output
programming.
The enable/disable
button enables or
disables a zone in
enable/disable
configuration mode.
It also turns on
and off the delay
to output
for individual zones.
1. To select
programming mode.
2. To cancel the
delay to output.
Switches the status
between test
enable, and test
disable for a zone
during test
programming.
The panel turns off
the zone power for
5 seconds.
Scan the zones
and check for any
alarm or faults
Press the
Left
Navigation
button.
Press the
Right
Navigation
button.
Press the
Enable/Disable
button.
Press the
Function
button.
Press the
Reset
button.
Log on to access
level 2.
Unlock the key switch.
When pressed for
5 seconds,
all LEDs on the panel,
and the buzzer,
turn on for 10 seconds
and turn off.
Panel controls not enabled at access
level 1 and on a fault-free panel.
Press the
Lamp Test
button.
Power on
Press the Buzzer
Silence button.
The buzzer turns off.
Delay to output override
17FireClass Essential Panels User Manual