14
Useful menu options
Accessing the event log
Complete the following steps to access the event log:
1. Press the 1 key to select the Analyze option on
the MAIN screen and then press the 8 key to
select Log. Alternatively, press the 3 key to
select View Log.
2. Use the alphanumeric keypad to select the
visualization of the filters. The selection allows
you to observe only a certain type of event.
The options are:
1: Alarm events only
2: Delay to alarm events only
3: Warning events only
4: Test events only
5: Fault events only
6: Restore events only
7: Generic events only.
3. Use the Right and Left cursor keys to scroll
through the data blocks and use the Up and
Down cursor keys to scroll through the events.
Loop check
Complete the following steps to check the loop:
1. Press the 1 key to select the Analyze option on
the MAIN screen.
2. Press the 1 key to select Loop.
3. Use the Up and Down curser keys to select
the loop to view. The panel will check both
sides of the loop before displaying the
configuration of the loop.
4. To return to the MAIN screen, press the ESC
key.
Viewing the device status
Complete the following steps to view the device status:
1. Press the 1 key to select the Analyze option on
the MAIN screen.
2. Press the 2 key to select Device.
3. Use the Right and Left cursor keys to scroll
and then press the ENTER key to select the
loop.
4. Press the ENTER key to view all the devices.
5. Use the Right cursor key to select the next
device and use the Left cursor key to select
the previous device.
6. To return to the MAIN screen, press the ESC
key.
Disabling points
Complete the following steps to disable a point:
1. Press the 2 key to select the Disable option on
the MAIN screen.
2. Enter the user password and press ENTER.
Each digit will be masked by an asterisk. The
default user password is 11111.
3. Press the 2 key to select Device.
4. Use the Right cursor key to select the next
available device and the Left cursor key to
select the previously available device. Press
the ENTER key to confirm the selected device.
5. Press the ENTER key to confirm the request to
Disable or press the ESC key to return to the
MAIN screen.
Disabling sounders
Complete the following steps to disable a sounder:
1. Press the 2 key to select the Disable option on
the MAIN screen.
2. Enter the user password and press ENTER.
Each digit will be masked by an asterisk. The
default user password is 11111.
3. Press the 4 key to select Output.
4. Use the Up or Down cursor keys to scroll
through the type of output to disable or enter
the SC number. Press the ENTER key.
5. If the sounder is disabled, the panel will
prompt you to enable it and if the sounder is
enabled, the panel will prompt you to disable it.
Press the ENTER key to confirm.
Loading a language from the USB stick
The USB option in the PROGRAM menu activates the
USB programming screen. Use the 7 key to select the
USB programming screen. The USB programming
screen includes the following options:
0: Extra
1: Load Audio
2: Save Audio
3: Load programming
4: Save programming
5: FW Upgrade
6: Save LOG
The loaded languages are the languages of the control
panel. The default first language is English and cannot
To Next Page
Loading...
