Need help?Do you have a question about the Firetrol FTA1100-J and is the answer not in the manual?
General instructions for mounting the controller on a wall or floor/base plate.
Step-by-step instructions for wall mounting the controller.
Step-by-step instructions for floor or base plate mounting the controller.
Requirements for electrical wiring based on NFPA, NEC, and CEC codes.
Precautions before making field connections, including inspection and verification.
Procedure for connecting incoming power, emphasizing battery connection order.
Visual check of the disconnect switch and circuit breakers positions.
Verifying water connections and connecting engine panel/AC power to the controller.
Setting pressure units, Cut-In, and optional Cut-Out values, then pressing "Service Done".
Sets the Main Selector Switch to AUTO for automatic mode, completing installation.
General instructions for mounting the controller on a wall or floor/base plate.
Step-by-step instructions for wall mounting the controller.
Step-by-step instructions for floor or base plate mounting the controller.
Requirements for electrical wiring based on NFPA, NEC, and CEC codes.
Precautions before making field connections, including inspection and verification.
Procedure for connecting incoming power, emphasizing battery connection order.
Visual check of the disconnect switch and circuit breakers positions.
Verifying water connections and connecting engine panel/AC power to the controller.
Setting pressure units, Cut-In, and optional Cut-Out values, then pressing "Service Done".
Sets the Main Selector Switch to AUTO for automatic mode, completing installation.
General| Brand | Firetrol |
|---|---|
| Model | FTA1100-J |
| Category | Controller |
| Language | English |
To Next Page
