Need help?Do you have a question about the Firetrol FTA2000 Series and is the answer not in the manual?
General| Model | FTA2000 Series |
|---|---|
| Frequency | 50/60 Hz |
| Voltage | 208-600V |
| Phase | Three Phase |
| Starting Method | Across the Line |
| Enclosure | NEMA 4, NEMA 4X |
| Listings | UL Listed, CSA Certified |
| Input Voltage | 208-600V |
| Output Voltage | 208-600V |
| Humidity | 95% non-condensing |
| Output Current | Varies by model |
| Dimensions | Varies by model |
| Weight | Varies by model |
Explains automatic, manual, remote, emergency, sequential, flow, and weekly start/stop methods.
Details manual stop, automatic stop, flow stop, and emergency stop procedures.
Specifies placement near motor, water protection, clearances, and ambient temperature.
Details secure wall/floor mounting and seismic considerations.
Covers water connection to the system and electrical wiring standards.
Emphasizes licensed electrician, watertight fittings, and debris protection during connections.
Covers wire acceptance, sizing based on load, and incoming power terminal connections.
Identifies motor connection terminals and installer responsibility for proper connection.
Advises verifying that the controller is securely installed on the wall or mounting stand.
Details drilling holes, running cables, and securing water input and drain connections.
Guides connecting input power and motor, applying torque, and verifying readings.
Explains the 'First Start Up' page, voltage detection, and frequency selection.
To Next Page
