Need help?Do you have a question about the Firetrol FTA1100-JL12N and is the answer not in the manual?
Specifies location requirements and provides an overview of mounting procedures and tools.
Verifies installation, selector switch, breakers, and outlines initial power-up.
Activates breakers, boots up the controller, and shows initial system status.
Describes entering an authorization code for first start up and detecting power/charger.
Guides on turning the selector to HAND and performing engine start tests on batteries.
Sets pressure units, cut-in/cut-out values and activates Automatic mode.
Specifies location requirements and provides an overview of mounting procedures and tools.
Verifies installation, selector switch, breakers, and outlines initial power-up.
Activates breakers, boots up the controller, and shows initial system status.
Describes entering an authorization code for first start up and detecting power/charger.
Guides on turning the selector to HAND and performing engine start tests on batteries.
Sets pressure units, cut-in/cut-out values and activates Automatic mode.
General| Model | FTA1100-JL12N |
|---|---|
| Category | Controller |
| Type | Fire Pump Controller |
| Frequency | 50/60 Hz |
| Controller Type | Across-the-Line |
To Next Page
