1.Unscrew the air cleaner cover by provided screwdriver.
2. Cut wire tie that is binding the black battery
6. The remote control is programmed to generator
successfully.
Remote Control Power Consumption
While the Engine Switch is in the “RUN” (I) position
and the battery power restore switch has been
pressed for about 3 seconds, the remote module is
active and waiting for signal. This function requires
electrical current which is consuming the battery.
THIS GENERATOR WILL AUTOMATICALLY
DISCONNECT THE BATTERY AFTER 12 HOURS
3. Insert the male connector of cable A into
TO AVOID BATTERY DRAINAGE, IF THE
female connector of cable B. GENERATOR IS
NOT RUNNING AND THE ENGINE
SWITCH IS LEFT IN “RUN” (I) POSITION. 4. Reattach the air cleaner cover.
YOU MUST GO THROUGH STARTING PROCEDURE
TO RESUME RUNNING THE UNIT AGAIN.
SPECIFICATIONS
To Next Page
Loading...
