EasyManua.ls Logo

Firman W03383 - Troubleshooting Common Problems; No Output or Power Issues

Firman W03383
188 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English Customer Service: 1-844-
FIRMAN1Page 37
non-conductive vacuum siphon. Any damages or
hazards caused by using
improper fuel, improperly stored fuel, and/ or
improperly formulated stabilizers, are not covered by
manufacturer's warranty.
Do not store gasoline from one season to
another season.
Drain fuel into approved container outdoors, away
from open flame. Be sure engine is cool. Do not
smoke.
TROUBLE SHOOTING
Problem
Cause
Correction
Engine is running, but no
AC output is available.
1. Circuit breaker is open.
2. Fault in generator.
3. Poor connection or defective cord set.
4. Connected device is bad.
1. Reset circuit breaker.
2. Contact authorized service facility.
3. Check and repair.
4. Connect another device that is in
good condition.
Engine runs good at no-
load but “bogs down”
when loads are connected.
1. Short circuit in a connected load.
2. Engine speed is too slow.
3. Generator is overloaded.
4. Shorted generator circuit.
1. Disconnect shorted electrical load.
2. Contact authorized service facility.
3. See Don't Overload Generator
4. Contact authorized service facility.
5. Clogged or dirty fuel filter.
5. Clean or replace fuel filter.
DANGER

Table of Contents

Related product manuals