English Customer Service: 1-844-FIRMAN1Page
20
8. Pull the starter cord slowly until resistance is felt and then
pull rapidly.
4. Turn the fuel valve to the “ON”(l)
position.
9. Push the choke
button to the “RUN” position.
5. Flip the engine switch to the "RUN"(l) position.
10. Allow generator to run
at no load for
fewminutes upon each initial start-up to
permit engine and generator to stablize.
Starter cord kickback(rapid retraction) will pull hand
and arm toward engine faster than you can let go which could cause broken 6. Push
the battery power restore switch for about
3 seconds and then release. bones, fractures, bruises, or sprains resulting in
serious injury.
When starting engine, pull cord slowly until
resistance is felt and then pull rapidly to avoid
kickback.
Keep choke lever in “CHOKE” position for only 1 pull
of the recoil starter. After first pull, move choke lever
to the “RUN” position for up to the next 3 pulls of
the recoil starter. Too much choke leads to
sparkplug fouling/engine flooding due to the lack of
incoming air. This will cause the engine not to start.
If engine starts after 3 pulls but fails to run, or if
unit shuts down during operation, make sure unit
is on a level surface and check for proper oil level
in crankcase. This unit may be equipped with a low
oil protection device. If so, oil must be at proper
level for engine to start.
Manual Choke Start
(When the battery is dead)
If the battery is dead or not able to produce
enough current to power the push button choke,
the choke itself can be operated manually to help
To Next Page
Loading...
