English Customer Service: 1-844-FIRMAN1Page
23
8. Press and hold the engine switch in the
"START"(ll) position for few seconds and release
the switch to the "RUN"(l) position.
9. Push the choke button to the “RUN”
position. 4. Turn the fuel valve to the
“ON”(l) position.
10. Allow generator
to run at no load for fewminutes upon
each initial start-up to permit 5. Flip the
engine switch to the "RUN"(l) position.
engine and
generator
to stablize.
Starting
the
Generator (Remote Start)
6. Push the battery power restore switch for about 3 seconds and then
release.
NOTE:
YOUR REMOTE CONTROL IS ALREADY PROGRAMMED IN
FACTORY FOR YOUR CONVENIENCE. AND IT IS READY TO START THE GENERATOR.
If the remote control is replaced, then you will need to go through programming procedure
in "Remote Control Programming" section.
1. Before starting the generator, check for loose 7. Push and release the ''START'' button on the or
missing parts and for any damage which remote control. The generator will turn over for
may have occurred during shipment. 3 to 5 seconds and start.
To Next Page
Loading...
