2-13 Timer Mode:
(Note: Must be set to on in order to operate timer mode).This feature enables the
user to activate and deactivate Timer Mode (see option 2-06) using the Firstech remote or
accessory (see the user manual for that remote for instructions).
FO1 - Off:
(default)
FO2 - On: user must still activate timer mode using their Firstech remote or accessory.
3-01 Parking Lights while Remote Started:
This feature changes the parking light behavior during
remote start.
FO1 - Constant output:
This option will keep the parking light output (+ and -) on steady
throughout the entire runtime (runtime based on feature 2-07 selection)
FO2 - Flashing output:
This option will flash the parking light output (+ and -) throughout the
entire runtime (runtime based on feature 2-07 selection)
FO3 - Off:
This option turns the parking lights off while the vehicle is remote started.
FO4 -
Off with lock and unlock only:
This feature is designed to eliminate redundant parking light
flash with lock/unlock when interface module flashes the parking lights controlling the Factory
security.
3-02 Confirmation Chirps:
This feature will allow the user to select a shorter siren output time to
simulate a quieter arm/disarm/start output.
FO1 - 30mS:
This is a 30 milliseconds siren output with arm, disarm, and start confirmation chirps.
It will produce a “medium” volume sound. (Softer than the standard 60mS output)
FO2 - 15mS:
This is a 15 millisecond siren output with arm, disarm, and start confirmation chirps. It
will produce a “short” or quiet volume of sound. (Significantly softer than the standard 60mS
output)
FO3 - 60mS: This is a standard 60 millisecond siren output with arm, disarm, and start
confirmation chirps.
3-04 Starter-Kill:
This option determines the operation of the GWA wire (Any POC on CN3)
Must be
programmed on Special Option Group #2.
FO1 - Anti grind + Starter interrupt:
this option will allow the GWA to provide a negative output
when the system is armed or remote started. This will enable a starter interrupt to prevent the
vehicle from being started with the key when in an armed state.
FO2 - Anti Grind only:
This option will allow GWA to provide a negative output when the system
is armed. This will enable starter interrupt and prevent the user from grinding the starter during the
takeover procedure.
FO3 - Anti Grind and passive starter interrupt: This option will allow for GWA to provide a
negative output when the system is remote started or the passive starter interrupt is engaged. This
will prevent the user from grinding the starter during the takeover procedure and enable starter
interrupt 45 seconds after the ignition has been turned off.
3-08 Horn Output:
This feature controls the horn output behavior during Arm, Disarm, and Remote
Start. (POC setting #8)
FO1 - On double lock only:
(default) this option is designed to simulate a factory keyless entry
system by providing a horn output pulse (based on the option selection of feature 3-02) each time
the lock command is sent a second time within 8 seconds of the first lock command.
To Next Page
Loading...
