Installation Instruction
Page 54 Panda_12mini_PMS_Digital_s00865_Installation manual.V02 - Chapter D: Installation Instruction 23.1.07
D.2 Generator Connections - Scheme
The generator comes supplied with all supply lines (i.e. electric cables, fuel lines etc.) already
connected to the motor and generator. The supply lines are fed through the capsule's front base
panel and are shielded at the capsule inlets with water-proof grommets.
All electrical connections, cable types and sizes must comply to the appropriate regulati-
ons. The supplied cables are rated for ambient temperatures up to 70°C (160°F). If the
cables are required to meet higher temperature requirements, they must be run through
conduits.
ATTENTION! Before working (installation) on the System read the section “Safety Precau-
tions” on page vii in this Manual.
Fig. D.2: Connections
Fig. D.3: Connections
2
3
4 7 81
5 6
1. Raw water inlet
2. Fuel supply (in)
3. Fuel return line (out)
4. Cable for external fuel pump
5. Motor oil drain hose
6. Cable for main power
7. Generator Starter-battery negative (-)
8. Generator Starter-battery positive (+)
1
2
3
4
1. Backflow from external expansion tank
2. Intake to external expansion tank
3. Exhaust output
4. Connection external ventilation valve
To Next Page