Installation Instruction
23.1.07 Panda_12mini_PMS_Digital_s00865_Installation manual.V02 - Chapter D: Installation Instruction Page 73
1. Speed sensor on threaded seat
2. Engine Flywheel (with gear teeth)
3. Generator housing
4. Retention/tightening nut
ATTENTION! For Panda 8000 and Panda 9000 the
speed sensor has to be mounted in axial direction.
1. Speed sensor on threaded seat
2. Engine Flywheel (with gear teeth)
ATTENTION! For Panda 8000 and Panda
9000 the speed sensor has to be mounted in
axial direction.
Fig. D.31: Speed sensor
D.7.4 Electronic starter control unit
If there is an automatic starting requirement and if the remote control panel is switched off, then
this automatic starting requirement is ignored. Automatic starting is only possible if after switching
on of the remote control panel the automatic starting requirement takes place.
2
3
1
4
1
1
2
2
To Next Page