23
OPTION ADJUSTMENT MODE
Out of balance recovery
1
2
3
4
With the washer on at the wall, but
off at the display, press and hold
and together for 3 seconds.
oPAd will show on the display.
Select
SPIN using the dial.
Press
OPTIMISE WASH to set the
number of recovery cycles to 2 or 3.
Press
to save changes and exit
OPTION ADJUSTMENT MODE.
If an out of balance load is detected, the washer will stop and try to redistribute the load.
To adjust the number of times the washer attempts to re-fill, OUT OF BALANCE RECOVERY
can be used.
To Next Page
Loading...
Need help?
General
