32
FAULT CODES
If a continuous series of beeps sound, all the lights turn off on the control panel and a
number appears on the display, a fault has occurred. The washer automatically enters this
mode when there is a fault. To stop the beeps, touch any button then perform the following
steps:
1 Turn your machine off at the wall.
2 Wait for 60 seconds and turn it back on.
3 Check the machine is level, refer to ‘Levelling instructions’.
4 Remove load and retry.
5 Complete a
RINSE cycle.
6 If the fault re-occurs repeat Steps 1 and 2.
If the machine still will not work call your Fisher & Paykel Dealer or Fisher & Paykel trained
and supported service teachnician to arrange service.
To Next Page
Loading...
Need help?
General
