33
Remove hanging brackets
1
Remove the M8 washers and M8 nuts fromthe
M8 studs at the top the door (A) using the hex
key and spanner. Keep the washers and nuts to
reuse later.
2
Remove the hanging bracket from the top of
each door and set aside (B) for later installation.
Attach the door and drawer handles (C)
3
Align the handle holes with the door panel
holes and secure with M5x25 pan head socket
screws (4 per each door panel).
Note: Door handle kit available and must be
purchased separately. Refer to 'Components'
(page 6) for more details.
Attach side brackets and straps (E)
6
Align the brackets and straps to the holes on
the side of the panel and secure with #8x16
mush washer screws (20).
Attach the hanging brackets (D)
4
Align the bracket to the holes and secure
with #8x16 mush washer screws (14).
C
C
D
D
Internal box
B
Door panel
attachment kit
Side bracket
(10)
Side strap
(10)
#8 x 16
Mush Washer
Twin Thread
Philips Screw
#8 x 16
Mush Washer
Twin Thread
Philips Screw
#8x16 mush washer
(Custom) screw (34)
Door handle kit
M5 x 25
Pan Head
Socket Screw
M5 x 25
Pan Head
Socket Screw
M5x25 pan head socket
screw (12x)
Tools
Hex key
FPA spanner
Cross-head screwdriver
E
E
B
A
@0 DOOR PANEL INSTALLATION — CUSTOM
To Next Page
Loading...
