34
Attach the door panels
1
Open the door and loosen the M5x10 cross-head screws
(do not remove) at the sides of the doors (A).
2
Hang the door panel by inserting the M8 studs
through the holes of the hanging bracket (B).
3
Slide the forks of the side brackets onto the
screws of the door (C).
4
Screw the M8 washer and nut to each stud (D),
and re-tighten the side screws (E) to fix the
door panel (do not fully tighten). This will
allow opening the door without affecting
adjustment of the door panel.
B
D
C
A
E
Tools
Hex key
FPA spanner
(1)
Cross-head screwdriver
Powered driver (optional)
@0 DOOR PANEL INSTALLATION — CUSTOM
To Next Page
Loading...
