9
7 CUSTOM DOOR PANEL PREPARATIONS
The following drawings apply to non-Ice & Water models only. Dimensions are shown in
Metric (mm) and apply for the preparation and installation of custom door panels.
For Dwg and Dxf files of the below panel preparation download the folder on
http://thekitchentools.fisherpaykel.com
TOP PANEL – REAR VIEW
CUSTOM PANEL PREPARATION
TOP PANEL – REAR VIEW
Note:
Dimensions are shown in Metric (mm)
Dimensions apply for the preparation and
installation of custom panels.
For the second panel mirror and repeat dimensions
using inner bottom corner as the reference point.
Dwg and Dxf files of the above panel
preparation download the folder on
http://thekitchentools.fisherpaykel.com
392.3
54.8
35
297.4
50
457.5
50
126.1
34.7
414
R1.25 REF
12x Pilot holes recommended for
bracket attachment.
(Do not penetrate front surface).
All measurements to be made
from inner bottom corner.
For the second panel mirror
and repeat dimensions using
inner bottom corner as the
reference point.
CUSTOM PANEL PREPARATION
BOTTOM PANEL – REAR VIEW
Note:
Dimensions are shown in Metric (mm)
Dimensions apply for the preparation and
installation of custom panels.
Dwg and Dxf files of the above panel
preparation download the folder on
http://thekitchentools.fisherpaykel.com
385
128
29.1
58.1
492
416
50
58.1
R1.25 REF
10x Pilot holes recommended for bracket attachment.
(Do not penetrate front surface).
BOTTOM PANEL – REAR VIEW
Handle Details
Top Panel – Ensure handle is mounted 65.03 mm from inner edge of panel to the centre –
this will avoid interference with brackets.
Bottom Panel – Ensure handle screw heads are counter sunk into back of panel to avoid
interfering with hanging bracket.
To Next Page
Loading...
