1
1 SAFETY AND WARNINGS
ImpORTANT!
SAVE THESE INSTRUCTIONS
The models shown in this installation guide may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please go
to our website www.fisherpaykel.com or contact your local Fisher & Paykel dealer.
2 BEFORE INSTALLATION
Please follow the installation steps below to ensure your appliance is installed and
operatescorrectly.
Power
The appliance must be installed so the plug is accessible.
To ensure that the appliance is not accidently switched off, connect your refrigerator to its
own isolating switch. Do not plug in any other appliance at this isolating switch.
For power requirements, refer to the information on the serial plate. This is located at the
front right-hand side of the drawer when open.
It is essential that the appliance is properly grounded (earthed).
Connect the appliance to the electrical supply (220V – 240V 50Hz) with the fitted plug
and lead.
Connections to the mains supply should be in accordance with local regulations.
Location
Your refrigerator should not be located in direct sunlight or next to any heat generating
appliance such as a cooktop, oven or dishwasher.
This appliance is intended to be used in household and similar applications such as
– Staff kitchen areas in shops, offices, and other working environments;
– Domestic farm houses and by clients in hotels, motels and other residential type
environments;
– Domestic bed and breakfast type environments;
– Domestic catering and similar non-retail/non-commercial applications.
Ice & Water models only
Your Ice & Water refrigerator must be installed by an authorised plumber or Fisher&Paykel
Authorised Repairer as incorrect plumbing can lead to water leaks.
Fisher&Paykel Appliances does not accept responsibility for damage (including water
damage) caused by faulty installation or plumbing.
Optional accessories kit
The standard appliance does not include door panels. To complete the integrated appliance
the customer should supply their own. All the hardware required to mount these door panels
to the refrigerator doors is supplied.
When designing custom door panels, these are only available for non-Ice & Water models.
Standard Fisher & Paykel kits are available (EZKleen stainless steel door panels, part
numbers: RD90U or RD90), and can be purchased through Fisher & Paykel Customer Care
Centre or online at www.fisherpaykel.com (this service is available to selected markets only).
R600a
This refrigerator contains flammable
refrigerant isobutane (R600a).
!
WARNING!
Electric Shock Hazard
Read and follow the safety and warnings
outlined in this installation guide before
operating this appliance.
Failure to do so can result in death, electric
shock, fire or injury to persons.
!
WARNING!
Cut Hazard
Take care – panel edges are sharp. Failure to
use caution could result in injury or cuts.
!
WARNING!
• This appliance is top-heavy and must
be secured to prevent the possibility of
tippingforward.
• To ensure that the appliance is stable under
all loading conditions, the anti-tip bracket
supplied can be installed according to the
following installation instructions.
To Next Page
Loading...
Need help?
General
