14
DIAGNOSTICS QUICK REFERENCE CHARTS
Fault Display/Download Mode
Press and hold KEYLOCK, then START/PAUSE for 5 seconds.
All LEDs & LCD segments except Keylock are illuminated.
Press START/PAUSE.
This initiates Pen upload via lower tub-home light pipe. At the same time
the current and then the previous fault code will be displayed in the LCD
screen and on the secondary control panel LEDs. To read the fault code
on the secondary display, refer to page 7 on Fault Codes.
Press KEYLOCK.
This will clear current fault code. Note: if Keylock is pressed again, the
previous fault code will be cleared.
Press POWER to exit.
To Next Page
Loading...
