15
Hardware Output Test Mode
Press and hold KEYLOCK, then START/PAUSE for 5 seconds.
All LEDs & LCD segments except Keylock are illuminated.
Press POWER once.
“HO” will show in the display (integrated: Heavy, Normal, Fast, Delicate,
Rinse LEDs showing)
Press START/PAUSE.
Scroll through the following outputs using Start/Pause. Turn the outputs on
& off using Keylock button.
Press POWER to exit.
Note: Scrubbing Brush = output on, No Scrubbing Brush = output off (on
integrated models a green LED above the start/pause button is used in
place of the scrubbing brush).
LCD Norm Fast Deli Rinse Hardware Output
Display LED LED LED LED
bL Off Off Off On Backlight
Er Off Off On Off Element Relay
Ld Off Off On On
Lid Motors (will run for 10
seconds)
dd Off On Off Off Detergent Diverter Valve
FU Off On Off On Fill Water Valve
P1 Off On On Off
Motor Wash direction
(2300-2850 rpm)
P2 Off On On On
Motor Drain direction
(4200 rpm)
rd On Off Off Off
Rinse Aid Dispenser
(dispenses current
setting)
dF On Off Off On Drying fan
LE On Off On Off Rinse Aid LED
C1 On Off On On Water Softener Diverter
Valve
C2 On On Off Off Water Softener Brine
Pump
°C
On
On Off On
Displays current water
temperature.
°E
On
On On Off
Displays controller rail
voltage
Tub Home Sensor test:- Keylock symbol on = tub closed, off = tub open
To Next Page
Loading...
