Fisher & Paykel DH8060P3 - TROUBLESHOOTING; Common Dryer Malfunctions

39
TROUBLESHOOTING
The following is a list of problems you may encounter when using this appliance and some
suggestions that may help to correct the problem. If you still have problems, contact your
Fisher & Paykel trained and supported service technician.
PROBLEM POSSIBLE CAUSES WHAT TO DO
Pressing POWER
does
not turn on
thedryer
Fault with household
power supply.
Try plugging in and turning on another
electrical device.
Dryer does
notheat
Full water tank. Refer to ‘Emptying the water
collection tank’.
The dryer has progressed
to
COOL.
Check the progress lights – are
COOLorEND lights illuminated?
Referto‘Control panel’.
Pressing
does not start
thedrying cycle
Dryer door not closed
properly.
Open and close the door. Checkthat the
lint filter is correctly in place and not
obstructing the door.
Is the dryer displaying a user
warning or fault code?
Refer to ‘User warnings’ and ‘Fault codes’.
Water tank full or not
properly in place.
Refer to ‘Emptying the water collection
tank’. Ensure the water tank is properly
inplace.
Dryer is overloaded. Remove some items from the dryer.
DELAY START function is set. Refer to ‘Delay Start’ for more
information.
KEYLOCK is ON.
To disable press
fortwo seconds.
Dryer keeps
stopping
andstarting
The
WRINKLE FREE option
hasbeen selected.
Refer to ‘
Wrinkle Free’ for more
information.
Dryer stops
working
mid-cycle
Power failure.
Press
POWER and restart the
desiredcycle.
Dryer has been paused.
Press
to restart thecycle.
Dryer door is open. Ensure the door is firmly shut.
Items fell off the rack
whenusing
RACK DRY cycles.
Ensure the rack is installed correctly
(refer to ‘Drying rack’) and replace
garments thatmay have fallen from it.