Name: Fisher & Paykel QuickSmart WA7060M1
Brand: Fisher & Paykel
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Lid open 09

Out of balance 10

Possible causes:

• The tang on the lid is bent or broken.

• The lid is open, close it and then press the start/pause button.

• The lid-lock assembly has failed. If the lid is closed and the tang is ok, replace the lid-lock assembly.

See 03 for possible causes.

Note: Only occurs if out of balance recovery is turned on.

Table of Contents3
Specifications5
Dimensions5
Electric Supply5
Wash Motor5
Inner Bowl Weight5
Pump Motor5
Diverter Valve5
Water Valves6
Thermistor6
Lid Lock6
Model ID Setting7
Installation Test8
Diagnostics9
Diagnostics Mode9
Diagnostics Levels10
Data Download14
Showroom Mode14
User Warnings14
No Taps 0115
Wash Level Overloaded 0215
Out of Balance 0315
Suds Lock 0416
Insufficient Hot Water 0516
Insufficient Cold Water 0616
Agitate over Load 0716
Lid Lock Failure 0816
Lid Open 0917
Out of Balance 1017
Wash Cycles18
Customising18
To Enter Option Adjustment Mode18
Controlled Cold18
Out of Balance Recovery Routine18
Wash Temperatures19
End of Cycle Beeps19
Fault Codes20
Motor Control Module Fault20
Model ID Error20
Temperature Sensor (Thermistor) Error20
Flood Protection Error20
Water Valve over Current21
Diverter Valve Not Connected21
Water Leak Fault21
Pressure Sensor Fault21
Pressure Tube Fault22
Bowl Dis-Engage Fault22
Temperature Sensor Fault (Thermistor)22
Display Memory Check Fault22
Cold Valve23
Hot Valve Coil Faulty23
Bowl Check no Valid Fault23
Brown out During Display EEPROM Write Fault23
Pressure Transducer at Maximum Adjustment24
Pressure Transducer Error - Count too High24
103. Slave Display Comms Time out See Fault Code 10524
104. See Fault Code 10524
105. Comms Error Time out24
107. Motor Control Module Reset Error24
108. Comms CRC Error - See Code 10524
112. Motor Current Sense too High24
133. Repetitive Current Trip25
136. Motor Stall25
137. Motor Loss of a Phase25
160. Bowl Engaged in Agitate25
220. EEPROM Model Map Not Programmed26
221. Motor Control Module Fault26
232. COMMS Timeout 5 Sec26
233. EEPROM Read Error26
234. Lid Lock Open Circuit26
235. Lid Lock Short Circuit27
241. Function Time out27
249. Pump Time out Fault (no Change in Water Level)27
254. Motor Control Version27
Wiring Diagrams28
Valve Recirculating and Dispensing (Cleansmart™)28
Valve Recirculating (Fabricsmart™ and Washsmart™ Eco)29
Valve Non Recirculating (Washsmart™)30
Valve Non Recirculating (Quicksmart™)31

Fisher & Paykel QuickSmart WA7060M1 User Manual

Table of Contents

Questions and Answers:

Fisher & Paykel QuickSmart WA7060M1 Specifications

Related product manuals

Brand	Fisher & Paykel
Model	QuickSmart WA7060M1
Category	Washer
Language	English