5
Water Valves
Note: The flow rate will vary depending on the supply pressure, maxium flow rate values shown in the
table.
Water Supply
• For the best operating conditions the hot water temperature should be approximately 60˚C.
• The hot water temperature should not exceed 65˚C or cold water temperature 35˚C. Temperatures
above these may cause the machine to fault or cause damage to the machine.
• If there is an uncontrolled water heating source (e.g. a wet back or solar heating) a tempering
device should be fitted. This will ensure the hot water temperature remains within safe limits. For
the most suitable type of tempering device we recommend contacting a local plumber or plumbing
supply merchant.
• Inlet water pressure 5psi (35kPa) to 150psi (1MPa) static.
Note: If using a header tank, then the outlet of the header tank must be at a height of at least 2
metres above the top of the console of the clothes washer.
Thermistor
NTC-type temperature sensor (Thermistor) resistance 10kΩ @ 25°C
Lid lock
Resistance: 63Ω +/- 10% @ 20°C
Note: Normally low voltage, potentially 230V if harness is shorted to earth.
SUPPLY OPERATION MODE VOLTAGE RESISTANCE FLOW RATE
Cold Digital 24V DC 61Ω @ 20°c (68°F) 16 litres per min.
Hot Digital 24V DC 61Ω @ 20°c (68°F) 10 litres per min.
Detergemt Digital 24V DC 61Ω @ 20°c (68°F) 5 litres per min.
Fabric Digital 24V DC 61Ω @ 20°c (68°F) 1.2 litres per min.
Wash boost Digital 24V DC 61Ω @ 20°c (68°F) 2.5 Litres per min.
To Next Page
Loading...
Need help?
General
