To Next PageTo Next Page
Need help?Do you have a question about the Fisher Research Labs Gold Bug and is the answer not in the manual?
Demonstrating detection of different targets and adjusting discrimination.
Features covered in the latter half of the demonstration.
Explanation of the main knobs and buttons.
How to power on/off and adjust sensitivity/gain.
Switching modes and adjusting threshold.
Using Ground Grab, Pinpoint, and Disc Level adjustments.
How to perform automatic ground balancing in All Metal Mode.
Adjusting Gain/Threshold and managing unwanted noise.
Interpreting Fe3O4, GND PHASE, and GND BAL values.
Understanding the arc display for target classification.
Setting Gain, Mode, and Disc Level for target rejection.
Narrowing down target locations without coil motion.
Interpreting the 2-digit Target-ID and signal strength indicators.
How '+' and '-' affect tone and target elimination.
How different DISC values affect target detection and audio.
Why ground balancing is necessary to cancel mineral signals.
Step-by-step instructions for performing automatic ground balance.
Understanding audio responses and 2-digit target identification.
Using high sensitivity and ground balance for gold.
How hot rocks sound and how to distinguish them from targets.
Strategies to reduce sensitivity and manage EMI.
Detailed steps for precise target location and identification.
Demonstrating detection of different targets and adjusting discrimination.
Features covered in the latter half of the demonstration.
Explanation of the main knobs and buttons.
How to power on/off and adjust sensitivity/gain.
Switching modes and adjusting threshold.
Using Ground Grab, Pinpoint, and Disc Level adjustments.
How to perform automatic ground balancing in All Metal Mode.
Adjusting Gain/Threshold and managing unwanted noise.
Interpreting Fe3O4, GND PHASE, and GND BAL values.
Understanding the arc display for target classification.
Setting Gain, Mode, and Disc Level for target rejection.
Narrowing down target locations without coil motion.
Interpreting the 2-digit Target-ID and signal strength indicators.
How '+' and '-' affect tone and target elimination.
How different DISC values affect target detection and audio.
Why ground balancing is necessary to cancel mineral signals.
Step-by-step instructions for performing automatic ground balance.
Understanding audio responses and 2-digit target identification.
Using high sensitivity and ground balance for gold.
How hot rocks sound and how to distinguish them from targets.
Strategies to reduce sensitivity and manage EMI.
Detailed steps for precise target location and identification.
General| Operating Frequency | 19 kHz |
|---|---|
| Warranty | 5 years |
| Sensitivity | Adjustable |
| Battery Type | 9V |
| Length | Adjustable |
| Ground Balance | Manual |
| Audio Output | Speaker and headphone jack |
