4
GROUND setting of “5” is probably not the
optimum setting for the ground you’re searching,
and that’s why the sensitivity level is lowto
reduce false signals caused by ground
mineralization.
2. Adjust the volume control for a comfortable
volume when the coil is passed over a large,
shallow target.
3. Travel slowly, overlap your sweeps and keep
the search coil moving. Remember, you’re in a
“motion” search mode, and the coil must be
moving at least slightly to detect a target.
4. When you get a good, repeatable signal,
pinpoint the target by placing the coil on the
ground away from the target, pushing and
holding the pinpoint button and then bringing the
coil back over the target.
5. Good hunting!
CONDENSED OPERATING INSTRUCTIONS
To Next Page
Loading...
Need help?
General
