FISNAR DC50 - Page 15

DC50 Digital Dispenser Operating Manual
© 2020 Fisnar - 15 - DC50 Rev 02
Press the button again to move to the next digit to the right of the one
that was previously flashing. Adjust accordingly to the correct numerical value
using the buttons.
Continue to press the button to scroll through the digit positions, adjusting
the numerical values as required.
When the button is pressed when the fourth (last) digit is flashing the first
numerical digit will start flashing, allowing you to cycle through the digit
positions again, in a continuous cycle.
Once the correct dispense time has been set, allow the digits on the display
screen to continue flashing. After 2.5 seconds, the digits will stop flashing and
the dispense time showing on the display will be automatically saved.
2.
Press the foot pedal or the button to start the machine and begin
dispensing.
The digital display will automatically start counting up from 0.000 seconds
until it reaches the saved dispense time.
3.
The machine will continue dispensing until the saved dispense time is
reached.
4.
When the saved dispense time is reached the machine will automatically stop
dispensing.